HP 6530b is a notebook computer product launched by HP in September 2009. It focused on the business market at that time, so the notebook adopts relatively excellent configurations and has a very excellent office experience and performance. However, notebooks at that time were just at an early stage of development, and the overall workmanship and parameter configurations of the computers were not considered advanced, but seemed rather old. But it was a great laptop for its time. So how to install the driver and disassemble the HP 6530b?

HP 6530b disassembly steps

The first step is to disassemble the keyboard, open the screws on the back, usually there are three, and then remove the screws on the keyboard Use the four clips to slowly lift up the keyboard along the edge of the keyboard. The direction and order is from top to bottom, and then pull out the cable on the keyboard. Of course, you must remember to pull out the clips first, and you must do it slowly. Next remove the two cables connecting to the motherboard. Cable No. 1 is the one closest to the keyboard cable. The removal method is the same as that of the keyboard cable. The touchpad has now been removed. To remove the fan connection cable, be sure to slowly pull it out upwards. Pay attention to the four-color wire. It can be pulled out while shaking from side to side. You must be careful because this is the most troublesome step in the disassembly process.

Remove the heat sink (made of copper, yellow), remove the two screws, and pull out the silver iron piece on the board to the right. Remove the heat sink: first slowly lift the heat sink horizontally, and then pull it out to the right (be careful where the left part of the heat sink is connected to the fan). The two square things under the heat sink are extremely important. One is the CPU and the other is the GPU. In this case, the disassembly of the notebook is basically completed. At this time, we can properly inspect and replace the hardware, and at the same time clean the dust inside the notebook.

HP 6530b driver upgrade and installation

About In fact, we have already said a lot about the methods of computer driver upgrade and installation. First of all, when we buy a computer, the store will give us a CD to install the driver. When we get home, we immediately turn on the computer and insert the CD at the same time. In the optical drive of the laptop, after the computer reads the optical drive, click on the optical drive to identify the installation file inside the optical drive, so that you can install the driver. In addition, we can also download and install a software called "Driver Wizard" and then enable the driver wizard. Check the computer's hardware driver. After the detection is completed, click Upgrade and Install directly in the driver wizard.

After the driver is installed, usually the computer will automatically ask us to restart. We make the decision to restart based on the actual situation of the computer. If all the drivers are installed, you can directly choose to restart immediately. If If the computer is not completely installed when it asks to restart, just choose to manually restart it later. Of course, you must remember that very important drivers such as graphics card drivers must follow the steps.